ADDRESS:Bldg A8, Xiashiwei 1st Industrial Zone
Fuyong, Baoan District, Shenzhen, Guangdong, PRC
RFID card reader can read, write, authorize, format and other operations. It has the advantages of multi-protocol compatibility, small size, fast read speed, multi-tag reading, etc. It can be widely used in various RFID systems.
Logistics and warehousing management: item flow and warehouse management, as well as the flow management of mail, parcels, and transport baggage;
Intelligent Parking Management: Automated parking management and billing;
Production line management: identification of production process points;
Product anti-counterfeiting detection: using the memory protection function in the tag to identify the authenticity of the product;
Anti-weighing system: It is used to identify the vehicles that have to pass the pound, such as the unmanned weighing system.
Management of transportation vehicles: bus reporting stations, parking management, vehicle transportation, sand vehicle, dump truck, etc.
Other areas of management: such as meeting attendance, club VIP, library, student status, consumer management, attendance management, dining management, pool management and other systems have been widely used.
Instructions for use
When the UHF desktop reader is powered on, the buzzer will ring once to indicate the start of work. When the card is close to the RFID desktop sender, the buzzer will ring once to indicate the sending of data, the same IC card, and between the two readers. The interval can be set by software. After reading the card, if the IC card is still in the area of the RF card reader, the reader will not be prompted and will not send any data. However, if the IC card is still in the range of the RF card when the interval time or different ID cards are exceeded, the reader will read the card continuously. Card, and output data.
The UHF desktop reader uses RF induction to read the card data. When using it, try to avoid close to the metal. When the reader is close to the metal, the radio frequency wave will be absorbed and shielded by the metal, which will cause the reading distance to shorten. At the same time, RFID desktop card issuers | card issuing machines are located away from motors (motors), transformers and other equipment to reduce the impact of RFID desktop card issuers.
The UHF desktop reader can be used with Wiegand26bits/Wiegand26bits/RS485 standard format devices.
The UHF Desktop Reader provides an SDK development kit with demonstration programs for VB and VC.
Working frequency national standard (920~925MHz), American standard (902~928MHz) or custom frequency band hopping or fixed frequency work
Support agreement ISO18000-6B, ISO18000-6C (EPCGEN2)
Frequency hopping mode Broad spectrum frequency hopping (FHSS) or fixed frequency, can be set by software
Automatically read the card at work mode, external trigger control card reader or software command read card, card reader can be set
RF power 0~30dBm, software adjustable Read distance recognition distance adjustment range: 0.0~0.5 meters
Card reading sensitivity dual polarization reading card
Read time single label 64-bit ID number read time <6ms
Antenna parameters external antenna
Support interface RS485, RS232, Wiegand26, Wiegand34, RJ45, USB
Operating voltage DC+12V
Reading card prompt buzzer, red and green work indicator, red light means power is on, green light means read work
Maximum power consumption is no more than 4W
Working temperature -20°C～+80°C
Storage temperature -30°C～+125°C
Operating humidity 20%~95% (without condensation)
Overall dimensions 118mm×108mm×28mm